Yarb

Sorry about that, went back in the thread and saw the address. They do produce it but are on back order.

@SteveJ , Does this supplier produce other tanks for the 280Z? Thanks..

CarPartsManual.com There you will find everything you need to know on model year/configuration. Once again please take a look. It’s the Z Bible on part number sourcing.

We’re you able to do a compression test/leak down measurement before disassembly?

Beat me to it @zedhead

Download or look for a FSM on EBay. The documentation is readily out there.

Looks like the wrong sensor. My 78 has the duel plug. Has to do with the fuel pump circuit.

Get a endoscope camera from Amazon for $30, there are 10 ft. And longer camera leads. It’s blue tooth. Set it up watch your caliper or WC on video and watch for bubbles. Used this with the speed bleeders. One man job and you can watch the real time video. Works great. Cool camera, you can use it for almost anything…

MSA has replacement shafts. Start fresh and the shafts they sell are stronger and have replacement joints.

@SteveJ Not sure I’ve heard this before about collection jar being above the bleeder. Is this necessary for the drum brakes in particular? Currently bleeding my new system with speed bleeders. Have a great pedal without booster assist. Fire the car up and pedal goes straight to the floor no resistance. I’ll start a new thread from here.

Very fortunate they did not snap off at the head. Still a lot of fun ahead once the housing is removed. Back and forth with small increments may have prevented them snapping off. Had about a 50% luck ratio trying that method. As you know sometimes it just isn’t going to budge….

I’ve always loved the sound a shotgun makes when your chambering a shell !!

Jar it with a sand hammer on both sides and it might pry off with a little persuasion. If you look at the FSM it will illustrate how it’s mounted on the head itself. Should pull off towards the driver side fender.

Looks like the one above number 1 intake/exhaust

Tried your link, No luck… takes me to the last page I viewed on Amazon.

Hey John, we’re you going to put that FPR on before you drop it in. Probably a lot easier than fighting with the FI hose leaning over the car. Pretty tight fit.

Getting that free money to stay home. Scary to think where you work is an open door to start a career and have benefits for a lifetime. Very Sad

Try tapping them in with a brass hammer or wooden block. Are you certain there bottomed out?

@jeffg78 beat me to it…..

Hey John did you try fitting the plate without the disc? Wonder if it’s a dowel issue.

And don’t forget I believe the Captain still has his flip phone!!

Awesome Cliff!! CONGRATS!!

Just trying to show alternative’s friend

I agree on the 24 series as being original. Unfortunately there aren’t many suppliers that go into the higher amperage ratings. Recently I found the 34 series AGM battery from Bosch. 770 CCA with a 4 year warranty Non prorated replacement. Just installed mine and it’s a bit shorter than the 24 series but with the spacer provided it fits fine. $238 Probably not for the purist Z owner but is has the cranking power and residual capacity.

The outside diameter of the 280z bushing sleeve is 35mm