Wanted
Ads from our classified system. You can reply to want ads in this forum.
646 topics in this forum
-
- 1 follower
- 0 replies
- 872 views
Looking for this gauge. Thanks
Last reply by hiyabrad, -
-
- 1 follower
- 3 replies
- 888 views
Looking for cold air and hearing the OEM air box is the way to go. Thanks.
Last reply by zKars, -
- 2 followers
- 5 replies
- 957 views
I’m looking for part #36 from the figure, below. Mine has one of the threaded studs snapped off. If you have one for sale, please either send me a forum message or send me an email at jimr20165 at yahoo dot com Thanks!!
Last reply by borini63, -
- 1 follower
- 1 reply
- 666 views
Looking for a good core . It must be known as a good core if I’m going to pay for shipping thanks
Last reply by madkaw, -
- 2 followers
- 4 replies
- 1.4k views
Looking for 5 speed trans to do an upgrade to my Z.
Last reply by Patcon, -
- 2 replies
- 789 views
From a 77 . Part that goes thru the firewall. Need one with a lot less rust -lol
Last reply by madkaw, -
- 2 followers
- 4 replies
- 1.4k views
Mine is broken, and I'd like to buy a good used one if available. Email: jimr20165 at yahoo dot com Thanks!
Last reply by SoCalJim, -
- 2 followers
- 10 replies
- 3.2k views
I’d like to buy it if you have one that you’re willing to sell. Thanks. jimr20165 at yahoo dot com
Last reply by SoCalJim, -
- 1 follower
- 0 replies
- 712 views
Looking to buy a good used Ashtray as mine is missing a corner piece on the main housing. thanks 2fourtyZ
Last reply by 2fourtyzee, -
- 2 followers
- 1 reply
- 2k views
These are the ones with the chrome trim on top of the perspex. came in 2 slightly different versions Prefer full set but will look at parts or damaged items- rings or perspex
Last reply by jhm, -
- 3 followers
- 4 replies
- 1.2k views
Looking for an experienced welder that can remove and replace/weld rockers and floor pans at a reasonable cost. All the shops are either too busy or want my first born. Willing to drive anywhere in the northeast if needed. Will order the rockers and floor pans. any assistance is greatly appreciated
Last reply by captainkim@yahoo.com, -
- 2 followers
- 2 replies
- 745 views
Looking for a triple Mikuni 44pph set up. Thanks!
Last reply by hiyabrad,
-
Recently Browsing 0 members
- No registered users viewing this page.