Leaderboard

Looks like I have mostly parts candidates in the hoard. None of then work smoothly.

Here is how this one was wired: Main GND (B) is a male spade that pushes into a female held in that little box. Red/Black (RB) is the GND from the door switches. Red/Blue (RL) is +12V from the fuse box. And they're both female spades. You'll notice that the main GND can be interrupted by the switch and that the RB GND from the doors is independent of the dome switch. Now. To refurbish this one AND try putting it back together - so that it still works...

That is true, but it could have been converted from auto. I'm just throwing out bread crumbs. Something is drawing too much current. Find the thing.

I can attest to the fact that the Kia Sportage weatherstrip requires no adhesive (even at the top rear corner of the window) to conform to the shape of the window opening. That's because it uses a more modern design, wherein integrated metal Z-coils replace the need for adhesive or a separate gripper strip. The Kia design also uses a 'lipped bellows' design that provides a more effective seal than the Z's old-fashioned (sorry) cantilevered-lip design. The recent arrival of Z Store's retro-design weatherstripping (i.e. cantilevered-lip design) presents a bit of a dilemma to restorers, because they (apparently?) don't also offer a repro of the gripper strip. If I've got this right, it means that you have to use an adhesive to make the weatherstrip not only conform to the window shape, but also stay that way for some reasonable period of time. If your definition of 'reasonable period of time' is 20+ years, then use just use epoxy and be done with it. Otherwise, I think that 3M's 'old-fashioned' weatherstrip adhesive will do just fine (provided that you read and follow the instructions). It will also offer some forgiveness if you happen to; a) screw up during the installation, or; b) decide, a few years later on, to try something 'more better'.

IIRC, there may be something funky about the the cabin light's wiring and switching logic (even one of the terminals is 'different') that requires a special testing procedure. I'm thinking about how the lamp is controlled not just by its integral switch, but also by the door P/B's (wherein toggling the integral switch can override Door Open/Closed). Bottom line: You may not have a problem at all (emphasis, however, on the word, 'may') Perhaps we should ask CZCC's designated electrical expert (Steve ____? ) for some guidance before you add yet another cabin light to your collection.

Gotcha. In that case, try this. The tach won't work, but the car should run. If this works, we'll deal with the tach next.

Cats can stop up and restrict the exhaust

to be honest i havent even looked at the exhaust. Im assuming it does have cats. I did have a 10K potensiometer laying around and tested this hack from siteunseen and it did work when setting the ohms to ~1000. Car reved to 4500-5000 before shifting without any hesitations. im not planning on driving aggressive at all. but just trying to get the car running well.

Yeah, that's fair. It's real Ship of Theseus situation.