Yarb
Subscriber
-
Joined
-
Last visited
Everything posted by Yarb
-
Ordered a set from my local Nissan dealer yesterday.
-
Put in an order from Mc Master
-
Very Nice! How much are those toda? Shipping and installation had to be a big part of the cost.
-
Hopefully you noticed when removing the old seal that the seal is shall I say inverted. Meaning you drive it in upside down from the outside of the cover. Hope that makes sense. I used Permatex Anaerobic sealant on the gasket per @dave wm recommendation. Worked fine for me.
-
These Old Girls are Tired and need some love. Great work friend!
-
-
-
What was OER’s response that you received 2 weeks later? Thanks -
Looks like the valence.
-
Could it possibly be the male latch on the hood itself somehow being misaligned?
-
Running a stock motor anything over 40 is too large IMO. You are talking 150bhp.
-
Would be very interested to hear the negative feedback on The OER carburetors. When you reference DSI are you speaking of Datsun Spirit in Manassas Va.
-
You haven’t mentioned from what I see information on the engine you are working with.
-
Incredible work friend
-
-
Hey Cliff is that the Ole rubber orange on fishing line to mark your spot in the garage!!
-
-
I would say lay it out in the Sun but I see you’re from Indiana. Probably not the best time of the year.
-
Beautiful Work there friend!!
-
The camera will give you a better idea for many parts of the car including the radiator support and front rails as well. Once you find an area that looks satisfactory Eastwood makes a product to coat those areas with an extension nozzle to reach deep inside.
-
Free returns although I’d have to do the math to see how much greater voltage drop you would be getting going to the coil. That would be a @SteveJquestion.
-
My lower brackets on the same louvre you have are reversed where they are hidden underneath. I guess it was a tech preference for whoever did the original install back in the day.
-
Do yourself a big favor and get the Nidage Borescope from Amazon for less than $30 and look up inside the frame rails through the drain ports. You might be surprised by what you find. Also take a screw driver and tap along the bottom frame rail and see if you find soft spots. It’s a blue tooth setup that’s pretty cool. At least you can see what you have to work with.
-
Not sure how much or any difference that would make. Have you checked it with power? The results will be the same whether its on or off the motor. Opening and closing properly. Most Ive found are ether frozen open or closed.
-
@SteveJ Have any input on this being a 260 owner?
