siteunseen

I've learned a lesson today. No more sharing info at a gas station. Just with you guys. "I know nothing!"

You can turn a long one into a short by drilling the pin holes higher. Member Madkaw did it with success. Now I have to drill the 2 front lids that I have left over for a set I'm rebuilding.

@Captain Obvious Right up your alley from what I remember about your bike and those water tubes. @rossiz too. He has some Ducatis.

Nope! All good here. Waiting on cooler weather to put my new valves in a set of float lids. I'll have 4 good lids to swap out and see which valves work best. Hard to take apart a great running car at the moment. Oh yeah, mine had glass balls too! I think that's better from what I've read. Thanks again!!!

Cleaned up a little

What's this from?

Pm your address and I'll get it on the way tomorrow. You want the chrome looking thing too? Might as well send both.

Yep. Only one but it's yours.

I have one. My small stuff box stuff...

That SEM rust inhibitor works good but it turns blackish after applying.

I'll look today. Let you know asap.

Way off, $5,000. Told me where they could buy one for a few thousand. "Here's my phone, call them and I'll buy it today". Then didn't know was it a 2.4, 2.8, Z or ZX. Oh yeah also said no way was the paint original. That's when I quit being polite. its too hot to argue with rednecks.

Burned up some older fuel this morning. Refilled with fresh at a busy gas station/McDonald's and had 3 experts tell me what my car was worth. Small town stuff. Get a quart of oil and a Quarter Pounder in one place. Also free Z appraisals. ? Dicks

Maybe a Flood Car...

Nice! This one qualifies for the "Zs only a mother could love". It also has that "Kardashian Wide Body Kit".

I'm happy for him if that helps. ?

Looks a George Barris car. ?

Distributor advance curves S30-S130.xls Look at this, should help.

I beat you finally CO! My typing is faster versus your flip phone.

My bad! I didn't catch that, I was watching Fast Times and The Breakfast Club...

Nuke it from obit? That's funny Kim Jong.

Spraying carb cleaner on there is also a good way to clean one. I soaked mine in lacquer thinner for a few days then hit it with 120psi air gun. Theeeeeen OCD'd the spray holes with 4 penny finish nail. You should also go with a high flow oil pump from a turbo ZX if you really want to soak the valve train.