Leaderboard

Yup, 7/16-20 for the seat belts. M12 is a valid spec as well from some DOT document I found 15 years ago when I was researching aftermarket replacement belts. No idea what manufacturers adopted world wide. Also curious what seat belt threads were used on the various early 60’s datsuns (411, roadsters etc). The 1/4-28 are on the two Z hood bumper . Craziest thing I’ve ever seen. Must have been supplier determined at the time.

Wait until you find out about power tools...

@EuroDat is the guy I'm pretty sure you're thinking of. He does some amazing things and always has great pictures to share his work.

I posted a recent issue with my Mallory ignition. The Uni-lite ignition module would test bad when the car would stop working but after it sat for awhile it would test fine and the car would run again. After changing the ignition module a couple of times, and with some input from this forum, it turns out that a PO installed a second shunt resistor in series with the first one. I removed the second resistor and so far the car has been working. I think the issue with the shunt was that on removing it, I observed the exposed coil of wire in the shunt was damaged and likely was not giving a constant resistance, possibly no continuity at times. Even if you have just the single shunt resistor, if it fails like this one did, it might cause the same issue.

Reading a story about Craftsman tools and found that they were owned by Stanley Black & Decker. Also learned that Stanley and Black & Decker had combined, back in 2010. Very much like Holley. Pretty soon everything everywhere will be made by a single company. https://en.wikipedia.org/wiki/Craftsman_(tools) https://en.wikipedia.org/wiki/Stanley_Black_%26_Decker https://www.holley.com/

I saw your comment @siteunseen Did you break a rule? 🔨

200,000! - 139,500 = 60,500

200k seems like a stretch. I like it but it wouldn't be worth the cost of admission to me