Leaderboard

About this Vintage Z - As I recall - this one first showed up for sale about 20 miles North of me. New Port Richey or Holliday Florida. A friend of mine went to look it over, and reported that it was very poorly cared for. The next time we saw it, was its first sale on BAT. My fiend remarked that it had been very well detailed for that sale and looked 100% better than his personal inspection. Now we see it again, with an owner that put some significant funds and I’m sure elbow grease into it - to bring it up to better condition. Will the customer modifications hurt its market value? Not as much as the current market itself, the mod’s might hurt it a little as most collectors don’t want to mess with fixing anything.

And I thought it was some hot asian chick who drove a Porsche... O_O

Now that’s a smart Dawg!

I've used Hastings twice and didn't run into any problems. My dog has started eating those gummies all the kids are raving about. Now he just lays around and poots and then laughs about it.

Hi Site…..When installing new pistons and rings in an expensive rebuild, I want to feel confident that when I squeeze those pistons in the bores, they are perfect. The ITM pistons are awesome. When installing rings, I have found that the Total Seals oil rings mate up so easy that I can sleep at night shoving the pistons into the bores…….just me. I’m sure that ITM oil rings and Hastings will work, but I just never felt like I had them installed correctly….at least not in my mind. An extra $200.00 for top quality rings always seemed worth the investment…..whatcha think? BTW How’s your dog? Regards Guy

Never mind. I erased my internet history and the problem went away. Didn't know that "cookies" could do that. I think I had clicked on something by accident. Back to original programming...

I was preparing to remove the harmonic balancer to replace the front oil seal. Although the engine was wet with oil, I took a look at the area around the HB and noticed it was dirty, but dry. I then rag-checked the area behind the HB and confirmed it was dry - not leaking. I cleaned the engine and ran it for 10 minutes. I noticed the engine was wet in the vicinity of the oil pump and alternator bracket. The pooling seemed to be most significant under/near where the alternator mount bolts to the engine block. I removed the alternator and the bracket and cleaned up the area with a rag. Just to be sure it wasn't the oil pump I put a torque wrench on the four bolts and checked them at 13 ft/lbs (the spec is 11 to 15). I got a click on all of them. The timing cover was a different story. I started checking the bolts that weren't suspected of leaking and found they could all use about a 1/4 turn. The one just above the wet zone took a full two turns. The one just below took almost a full turn. It would appear that the significant oil leak was the result of two loose bolts on the timing cover. That was a heck of a lot easier then replacing a front seal.

That's exactly what the problem was on my car. I had a puzzling oil leak, seep, about a tablespoon every 30 miles or so. Small spot under my car after sitting. I knew the leak originated near the fuel pump, but was fearing the worst, head gasket. This was one of the last of 25 pages of doing a search for "oil leak" that I read. Decided to go check those bolts, YES! I had loosened the bolt to adjust the alternator but forgot to tighten it. The others in the sane vicinity were a bit loose also. Took it for a drive, no more leak.

I don't believe that can happen for the North American market 240Z. The brake light and turn signals share the same bulb for the rears. Look at the turn signal switch. That's where it happens. You can make an adapter plug, but you have to add a wire for the brake lights.