nix240z
Free Member
-
Joined
-
Last visited
Everything posted by nix240z
-
I own all the molds for all the parts, so I can make any part anytime. Just because webstore says out of stock does not mean I don't have it in-stock. -
probably from the same seller of the original fake hubcaps that sold on ebay. I did read a review that some of the hubcaps flew off the car while driving.
-
Keith, I believe the holes are for the seat guards. Which would be 3 on each side. One on the front and two down the side. Steve
-
I have both the futufab bumpers and the SS from Harrington. Futufab are the ones I went with on my car because they fit better. I'm located in Greer...
-
motor pushes out... also new rubber housings are available.
-
I would need a good working sample of the part to reproduce it.
-
lube up the gasket with wd40....
-
https://www.240zrubberparts.com/apps/webstore/products/show/5592472
-
I would try to cut and patch and not touch the pillars because what you cant see is the multi-layers in the pillars. This is a picture of what you will find when you cut the front pillar below the roof line 3-4 layers
-
You would only be able to weld the outer metal frame and not the multi layers inside which make up the structural part of the pilars. Also it would have to be measured and replaced perfectly or the windshield would not fit.
-
maybe you could post some pictures of the rust areas....
-
I used a lead kit from Eastwood.... https://www.eastwood.com/eastwood-deluxe-body-solder-kit.html
-
a few pics... after replaced roof skin... multi layers of metal.... sunroof skin out... drill spot welds from top lead front pillar.. donor roof ... drill spot welds from bottom/inside on this one. after.....
-
you just remove the skin from donor roof and cut out about 93 spot welds on each roof. Then install new roof skin. You will not want to cut the pillars because they are formed by muti-layers of metal. torch out the factory lead at the 4 seams.
-
$1655 shipped...
-
New ZcarGarage CV's
-
The new ones from nissan are more rounded vs square original style. original style reproductions https://www.240zrubberparts.com/apps/webstore/products/show/4484439
-
if you contacted me about the seat guards via email please check your email and spam folder also. Sometimes my emails go to spam folders.
-
www.240zrubberparts.com I am making a new batch of parts over the next few days....
-
zstory full exhaust...
-
Finally got the Rebello 3.2L in the car.....
-
industrial strength urethane.
-
$10 for roller and cup or $5 each for cup or roller..plus shipping
-
I have the rollers and cups. Grind off the back of the shoulder rivet and press out the rivet. The press back in the rivet and put a small tack weld on it.
-
upper quarter window seal used on the 69-73 240z I have 2 in stock https://www.240zrubberparts.com/apps/webstore/products/show/4423416
