nix240z

Looks great, thanks for sharing all your pictures... Steve

Installed new rubber on the main wiring harness body clips Before After

I ordered their 240z door weatherstripping a month or so back from their website and it came within a week. Never did get notification it was shipped, it just showed up. So no problems as far a getting the product. Steve

on a side note I would like to thank Norm at www.zeddsaver.com for plating my right and left door window frames. These turned out looking like brand new frames.

do you need the black ones? 240z have clear.

I now have the correct style Battery cable boot for the original style terminal, which is a top post right hand elbow. I can also reproduce this is Red. Steve

I have exact reproductions of the boots, I know a little pricey but all my products are hand made. http://www.240zrubberparts.com/apps/webstore/products/show/5644516 Steve

I sandblasted and wire wheeled each and every part. I also tried a vibratory tumbler with just about every media and gave up, hope you have better luck than I did.

all parts....

I blast the parts first, then wire wheel polish before the plating. I know there is a lot of trial and error until you figure out what works best for you with your bath set up and technique for the plating.

make sure you keep your old plate because you will need to drill new holes in the new one, since it does not come pre-drilled Steve

What a great find. Steve

Thanks Charles.... I ordered a Ez car lift today, so I will be getting the car off the dolly and putting her back on the ground for the first time since 2011.

I'm coming down the homestretch now. For those that have not kept up or known about my restoration, I have been keeping a log over at hybridZ or you can just look at my pictures here: http://www.240zrubberparts.com/apps/photos/ I have over 200+ pictures of my restoration. http://forums.hybridz.org/topic/110329-71-240z-18-months-of-work/ Rears today with Arizona Z car rear end, coilovers and Tokico Illuminas. Refurbished 280z stub axles with 280zx turbo companion flange adapters. New bearings, seals, rotors, calipers and plated hardware. Steve

installed new front end. New coilovers, Tokico Illuminas, R1 Concepts rotors, bearings, seals, calipers, Arizona Z car suspension, tie rods, 555 ball joints and plated all the hardware.

keep the pictures coming. Steve

sweet...

I just measured one of my Suspension Techniques springs that is out of my car and it is a little less than 11 1/2". I cant remember if that is the front or rear spring but it is a Suspension Techniques spring. and you will not need a spring compressor with these springs. Steve

This post will help with the collar. http://www.classiczcars.com/topic/27991-wont-go-into-gear/?p=246659

Can you share the photos? Steve

1 speaker only from the factory in the 71 cars. steve

I installed the MSA strut vinyl without a problem.

I would love to see more detail pictures of your cars, so keep them coming. Steve

I love seeing detail pictures of your car. Also I had seen this picture yesterday and I said to myself " that is Kats car".

sounds like you have a 73 pedal box.