My 71' 240z project ... =)

[justin260z]

Haha, all the time

"...or do you care" - don't get me started. Of course it'll be adressed.

:stupid:

haha ok just making sure

[Bart Hoedemaker]

Hey,

Nice work you have done there Mull. I was following your project a wile, great work. Look at my topic of my 240z, i think it is in the same condition as yours wass...

Keep up the good work!

Bart.

[mull]

Here's the latest:

Got some spindles/5-lugs donated : )

Mounted on my spindles (less rust then the donors...)

The hunt for trial wheels/rims begins... : )

For sale

[justin260z]

Awesome.

You know what would look killer on that?? A set of r-34 gt-r wheels. That would be bad!!

[Bart Hoedemaker]

Nice work.

[mull]

Here's a set of 18" loaner wheels taking a spin to check clearance. Car isn't at its lowest

since the wheels are an inch or so outside of the fender lips, meaning cutting will be next.

[ToXIc]

awesome work......

(p.s love the suspenders)

[Bart Hoedemaker]

What is the original rim size 15 inch?

[mull]

What is the original rim size 15 inch?

Madness! It's 14" : )

Chop chop...

Going offroad? Suspension isn't hooked up...

This is what rust free fender lips look like. Promise.

Torment.

Would you believe it? The other side was rust free too!

Close look. No rust as far as the eye can see.

Worn out disc making me use manual shear for the last cuts. Yay.

And presto, enough room to fit 20" or drop it another 2 inches, but that would mess the IRS geometry up. Hmm. Anyone know if there are drop spindles for Skyline/200sx/240sx/300zx? : )

Design and placement of the flares yet to be determined. Think I put it a bit too high on this pic. I was tired

[Bart Hoedemaker]

It's not my style that fenders..they are to big! I love the rims but make the fenders around it a bit smaller. I think it messes up the cars detail.

But nice work again Mull!

I showed some of your project pictures from welding on my dutch vauxhall forum. People wheren't satisfied about your welds? I think they are nuts or something. But I and many here know your doing a great job.

I love to see the finished product, can't wait to finish mine!

I'm going for 15 inch american racing vector rims, with a not to fat tire.

[mull]

It's not my style that fenders..they are to big! I love the rims but make the fenders around it a bit smaller. I think it messes up the cars detail.

But nice work again Mull!

I showed some of your project pictures from welding on my dutch vauxhall forum. People wheren't satisfied about your welds? I think they are nuts or something. But I and many here know your doing a great job.

I love to see the finished product, can't wait to finish mine!

I'm going for 15 inch american racing vector rims, with a not to fat tire.

Some welds are crap, most are good - some are great.

What welds did they think sucked?

[Bart Hoedemaker]

Naah.. they don't liked the project at all.

The had something about the floor boards, the the beem "under" the boards isn't supporting the structure enough. And that you have to make patterns in the floor boards to make them stronger.

There just jealous i think. But don't care about that Mull.

Tjek out my project 240z if you like.