Leaderboard
-
Patcon
Subscriber
4Points11,186Posts -
dspillman
Subscriber3Points453Posts -
conedodger
Free Member3Points12,649Posts -
inline6
Subscriber2Points1,301Posts
Popular Content
Showing content with the highest reputation on 12/15/2024 in Posts
-
A new video is available to watch. Making a new ball for the front ball joint - wow!2 points
-
Pure luck2 points
-
I saw that. I thought the same thing when he made the ball joint. Just crazy! He also had to make two of the receivers he used for case hardening the ball joints and I suspect he had to make the fixture he used to mil the elliptical grooves in the ball joint heads!1 point
-
Ive never seen that early water pump. How did you source it?1 point
-
I would trim the qtr window one back. Maybe even at an angle. Do it in small steps until you like the results1 point
-
Couple more early correct pieces. That I’m not sure anybody would notice……. But, anyway, let’s make it right.
1 point -
I also used a straight pick in the screw holes to help pry it into place and line up the screw holes. They can be difficult to get in properly. I would use some of the Precision sealant lube. Do not use silicone on painted surfaces. It's is very difficult to get off later if paint work needs to be done.1 point
-
I've used two folded towels against the glass, two 2x4s on the towels, and a ratchet strap or two to push the glass in.1 point
