Anyone try or have these?  Maybe discussed before, but a quick search didn't yield anything.

https://www.ebay.com/itm/2X-Black-Car-Jack-Pad-Adapter-Durable-Rubber-Support-Repair-Pad-Tool-USA-Stock/264254036568?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649

I have those - homemade style.  A bag of cheap hockey pucks with a slot milled thru them.  The bag had 12 pucks so I was able to give a set to a couple of buddies.  They also work perfectly with jack stands to get the entire car off the ground.

38 minutes ago, jfa.series1 said:

I have those - homemade style.  A bag of cheap hockey pucks with a slot milled thru them.  The bag had 12 pucks so I was able to give a set to a couple of buddies.  They also work perfectly with jack stands to get the entire car off the ground.

Thanks.  I know I can find other jack points, but it is so much easier to use the side pinch welds as designed.  I get tired of getting on the ground, centering under the front cross member or rear end to lift.

I was tempted to fab my own until I saw these.

Please explain your process (steps) for getting the whole car up on axle stands when using the pinchweld strips as the jacking point.

9 hours ago, Namerow said:

Please explain your process (steps) for getting the whole car up on axle stands when using the pinchweld strips as the jacking point.

I'm guessing it utilizes two floor jacks.

23 hours ago, Namerow said:

Please explain your process (steps) for getting the whole car up on axle stands when using the pinchweld strips as the jacking point.

Hmmm I read that as support spots only, not necessarily complete car jacking from the pinch welds. 

1 hour ago, JSM said:

Hmmm I read that as support spots only, not necessarily complete car jacking from the pinch welds. 

You're probably right.

Then there are these: https://baddogparts.com/index.php?main_page=product_info&cPath=2_4&products_id=3&zenid=9fla6m8evi4gijiemd5sgrm9j0

@gnosez

I built mine in...

3/16” steel on the connecting plates. Lowest point on the car...