duffymahoney
Supporting Member
-
Joined
-
Last visited
Everything posted by duffymahoney
-
You should have posted the pictures! It tucks up so nice.
-
Lots of threads on here about it. Use the search feature, I think most people love it.
-
I asked whitehead about spirit garage, I would love to see pictures when yours gets in. It's my favorite exhaust routing design, but I don't like the clamp system much.
-
I am trying to get my series 1 ready for a local car show. The only thing left really is exhaust. Sadly my stock is shot, so I can't use that.
-
Sadly they are back ordered for at least a month.
-
Wish I could stream it somehow.
-
-
I added this 120v solenoid for the air. So when i use my foot pedal it turns the air and the slurry pump on. Works so much better this way. I had great luck keep the slurry mixed by every 30 seconds or so pointing the jet to the bottom and mixing up the slurry mix. I could tell the slurry would be different for a bit.
-
-
I don’t think vapor affects the aluminum at all. I think it just picks the dirt out of crevices. It won’t pull off silicone or gaskets very easily. Doesn’t affect zinc. Doesn’t damage anything Today I tried way less glass and had the same results. This valve cover was rough. Looks pretty awesome now. Trying to get the appearce to be uniform is time consuming. I just gave up. I plan on doing 3 covers. One wrinkle red, wrinkle black and this one and decide which I like the best. It it just barely big enough for this cover. The head will be tough to fit and get the ends done. Shouldn’t be that bad though.
-
-
-
-
Glad that reproductions are now a thing!
-
Thanks guys. Walnuts would be more abrasive then this by a lot. This is so soft that it doesn't even take sealant off or silicone. It's sort of looks fake its so nice. No idea on cfm. I have a small compressor at home that wasn't good enough. I could go about 1 minute before I need to take a break and let it recharge. Beads clumped a bit, honestly the amount of beads needed is so small. Tomorrow I will try much less glass and see how it works.
-
-
I ended up using more of the water tight cord connectors, I also used a shower drain to make the vent pipe. Stock vent was just a aluminum cap with holes. This vent is just like vapor honing uses. Trying to dial in how much air to use. Might get to try tomorrow. I think I’m done for now.
-
Someone paid some dollars! If you need tuning advice contact David Premo. http://tuning4performance.com/
-
-
They don't do much mikuni stuff these days.
-
-
Dpan on facebook and a few guys hoard them. The going rate for a set of rebuilts is like 2,500-3k. Watch craigslist and have cash ready and be patient. They pop up.
Important Information
By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.