lan240

Datsun 260Z 280Z Tail Lights EUROPEAN Set on e-bay http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2411557857&category=34207

Here is a shot of my new air dam

Here is a picture of my steering wheel. It is a 14in wheel.

Here is a set of 350z seats on e-bay http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2410427604&category=33748

I built a box like the one that MSA sells. I improved on that design by enclosing the back and creating separate boxes for each speaker. It only cost $22.00 to build and about an hours worth of time. Looks and sounds great.

I am looking for a 5 speed Trans for my Dad's 240z. He is located in DeLand FL. If any one knowes where he can get one around there let me know.

Thought someone could use these http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2409155577&category=33748

Check the vacuum lines coming off the brake booster. It sounds like your problem. I had the same problem and I replaced the hoses and it fixed it.

Mississippi. You left out the south

Do you have any pictures?

Where are you located? Any pictures? Thanks Greg

I need some help with my 72 240. It has a Pertronix ignitor new NGK plugs, new fuel filter, cap and rotor. The car idles fine pulls hard through all gears but once I reach cursing speed it acts like it is missing. This all started this weekend after I filled up with gas. Could it be a bad tank of gas or what. Thanks Greg

I found this on e-bay and thought someone could use it. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2402558480&category=10076

That is an early 240 bumper 70 - 72. 73 bumpers were equiped with different mounting brackets. The vertical parts have been removed and the holes are filled with crome bumber bolts. This is the same bumper set-up that I have on my 72. MSA has a bumper that does not have the rubber strip on it also and you might check ebay.

The bolts you are trying to remove are the ones that are installed at the factory and the head is broken off to make it harder to get off. You can drill them out or try to make a slot in them and use a screw driver

If you install the k&n filter to the valve cover or leave it disconnected you will have a problem with fumes entering your z

I thought someone could use these http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2400932414&category=33638 Thanks Greg

Here is a ser of Watanabe rims I saw on e-bay. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2400858255&category=33748

The retractors fit fine in the pockets behind the seat. The only problem I have is the mounting point on the rear strut tower. If any one has a picture of a 280 that has the seat belt mounted to the strut tower that would be great. I also need a picture of a 280 strut tower with out the covering.

This was listed in Hot Rod under the new stuff. It is called Chassis Saver by Magnet Paints. It sounds a lot like POR 15. Here is the link. http://www.magnetpaints.com/underbody.asp