WTB: 81 - 83 shift lever Wanted

[7tooZ]

interesting pic, I know the ZX shifter is a lot shorter than the Z to start with, those extra bends would make it sit even lower. Would like to see what it looks like installed.

Reverse

5th





Sent from my iPhone using Classic Zcar Club mobile

[JSM]

3 hours ago, 7tooZ said:

 

 

Reverse

5th





Sent from my iPhone using Classic Zcar Club mobile

 

 

Is it bent int the shape siteunseen posted above?

[7tooZ]

Actually that photo is from me on an earlier post. Close but not the final version


Sent from my iPhone using Classic Zcar Club mobile

[gundee]

On 10/18/2017 at 10:07 AM, JSM said:

I sent you a PM.  I'll take it.  Want to play around with this a little.

Boxing it up tonight. You should have it soon. 

[gundee]

On 10/17/2017 at 8:16 PM, siteunseen said:

I think it's gonna look like this...

That looks similar to a Ford T5 shifter. A person could find one cheap and weld Ford top portion to the ZX shifter.

Not sure if it would work. Would have to experiment unless someone has already done it.

Edited October 20, 2017 by Lumens
photo

[7tooZ]

That looks similar to a Ford T5 shifter. A person could find one cheap and weld Ford top portion to the ZX shifter.

Not sure if it would work. Would have to experiment unless someone has already done it.

Looks like the pivot point would be too high for what Joe is trying to accomplish of using a late 70 5-speed and a series I console without major cutting of the tunnel or console.

If you have one send it to me and I’ll do some comparison. I will have my console and center bezel out to find out why my heater motor isn’t getting power.

 

 

Sent from my iPhone using Classic Zcar Club mobile

[JSM]

On ‎10‎/‎19‎/‎2017 at 10:32 PM, Lumens said:

Boxing it up tonight. You should have it soon. 

Thanks again!