Hmm? why P79 head????

Is that some type of ceramic heater to get hot enough to straighten cylinder heads?  

You got one helluva hack saw!

Cut off wheel(ssss) 

straightening a n47 head in a kiln

Looks like a nice work holder for the port grinding you're doing also.

Have you tried the heater yet?  Probably makes a nice pizza too.

Yes- makes for a nice heavy stand . Yes - I’ve had one semi successful run and it works pretty well. Need to dial in my technique.

3 hours ago, madkaw said:

Yes- makes for a nice heavy stand . Yes - I’ve had one semi successful run and it works pretty well. Need to dial in my technique.

Who's into ceramics?

Nice for setting the wipe pattern too, pretty much any head work.  I had to use a overhead chain hoist to get a bare block on my work table.  The one you have looks liftable by hand.  I wonder if a plasma cutter would work?  I got a friend that knows a guy...

2 hours ago, Patcon said:

Who's into ceramics?

Guy powder coats with it . 

5 minutes ago, siteunseen said:

Nice for setting the wipe pattern too, pretty much any head work.  I had to use a overhead chain hoist to get a bare block on my work table.  The one you have looks liftable by hand.  I wonder if a plasma cutter would work?  I got a friend that knows a guy...

Anything that cuts- torch , plasma cutter , partner saw would be the fastest 

1 hour ago, madkaw said:

Guy powder coats with it . 

Oh, cool. Looks like it might have been a ceramics kiln at one point

4 hours ago, Patcon said:

Oh, cool. Looks like it might have been a ceramics kiln at one point

It was meant to be 

Rotisserie started!