Attention All Mikuni Users

[Chickenman]

That Inline 6 sounds so sweet....

 

 

[Travel'n Man]

16 hours ago, Lumens said:

I wish I could get 32mm Chokes for my 44PHH. I am at the smallest at 34mm they make for the 44's.

I think the 32mm choke would be pretty much ideal for the street. Throttle response would be much better,

which I like more than a few extra HP at the top end where I never drive it anymore.

Steve - call David and see what he has - he may have the chokes you are wanting................

[acador]

I 2nd Travel'n Man's comments on David Premo.  I called David looking for help with a heat soak issue I've been fighting for years and not only did he immediately nail the fix he also suggested a jet change that really helped the top end power. This guy clearly knows how to tune Mikuni's.

[esmit208]

On 5/9/2016 at 4:35 PM, madkaw said:

Did you say throttle response!!

 

 

THAT THING SOUNDS TITS!

[gnosez]

And now consider six of those carbs on a Ferrari or Jag engine.

I have had triples for some time and the inlet suction noise is addictive.

[madkaw]

You know what's funny is that I have never enjoyed that induction sound because my airbox muffles that. All I hear is engine and exhaust . 

And I have contacted several folks about larger chokes than 32 for 40's , and they don't exist for the most part. I would need to modify/enlarge mine. The good thing is that if I go to large , there are used 32's out there to pop back in

[madkaw]

You know what's funny is that I have never enjoyed that induction sound because my airbox muffles that. All I hear is engine and exhaust . 

And I have contacted several folks about larger chokes than 32 for 40's , and they don't exist for the most part. I would need to modify/enlarge mine. The good thing is that if I go to large , there are used 32's out there to pop back in

[madkaw]

You know what's funny is that I have never enjoyed that induction sound because my airbox muffles that. All I hear is engine and exhaust . 

And I have contacted several folks about larger chokes than 32 for 40's , and they don't exist for the most part. I would need to modify/enlarge mine. The good thing is that if I go to large , there are used 32's out there to pop back in

[Captain Obvious]

Is there enough meat to open up the ones you have, or is the wall too thin?

I have a lathe, but don't have CNC so curves are done semi-freehand. I can do simple stuff. PM me if you're entertaining modifying what you have.

[240260280z]

1 hour ago, Captain Obvious said:

I have a lathe,

 

[Captain Obvious]

And I'm not afraid to use it?