Everything posted by mdbrandy
-
1978 280Z electrical gremlins
Cool. I'll certainly check that out. But if I broke it, or loosened it's connection, why would everything work in the 'on' position of the ignition, but not the "acc" posiiton? That'll probably take some schematic reading...
-
1978 280Z electrical gremlins
Well, all of a sudden this morning, I've developed a fairly serious electrical gremlin in my 280. I know it's pretty tough to diagnose on the forum from reading about everybody else's gremlins, but I wanted to post the symptoms to see if anyone recognizes the problem. Parked last night. No problem. Came out this morning, started right up, and the radio acted like it had lost power (no memory). Then I noticed that the clock had stopped too (and yes, it had always kept perfect time before). While the car is on (engine running), all is fine. Volt meter shows correct voltage, all lights work. As soon as I turn the key from On to acc to turn the car off, the radio loses power, the dash goes dark, and all rear lights go off. There is also a loud relay click at the passenger kick panel at the same time. The headlights still work. If I turn the key back to the on position (but don't start the car), all guages go to their appropriate positions EXCEPT the voltmeter, which stays at zero until I start the car, at which point it goes up near 15V and all is well again. Before today, the voltmeter always just dropped back to 12V or so when I turned the car off. In the ACC position, there seems to be no accessory power at all, and no lights except headlights. I'm assuming the relay I'm hearing is the ignition relay, but I don't know yet. The only "smoking gun" is that last night after parking the car, I replaced the two plastic covers over the fusible links in the engine compartment. I didn't start the car after I did that. After studying the electrical schematics for a while, I'll be taking a look at the area around the fusible links first, but I can't imaging what I might have done. If I had broken one of the links, I would think that something would be always off instead of working when the car is running. Oh, and I should mention that this morning while driving, the radio died 3 or 4 times randomly and immediately came back. Didn't happen at all driving home tonight. Any insights or recommendations would be very welcome before I start digging into circuits, grounds, etc. Thanks.
-
I hate this... Vacuum Water Cock.. in the heater/air conditioning??!!
Several posts ago, I said: Essentially the valve doesn't let hot water into the heater core when you have either the vent or AC active. I don't know about the rubber seal. Good luck.
-
I hate this... Vacuum Water Cock.. in the heater/air conditioning??!!
I guess I'm not sure what your question is...
-
I hate this... Vacuum Water Cock.. in the heater/air conditioning??!!
I looked at the drawings more, and it looks like it is that vacuum valve. It shuts off coolant flow to the heater core if the HVAC controls are in the vent or AC position, and lets coolant flow through the core in heat positions. There are about 6 other drawings in the manual similar to the one I posted that show the position of the vacuum valve and vent flaps in various HVAC control positions. Hope this helps.
-
I hate this... Vacuum Water Cock.. in the heater/air conditioning??!!
It's from your '78 280Z, right? The 78 that I just took apart didn't have one of those. Looking through the factory manual (do you have the factory manual on yours?) it looks like it is a vacuum actuator valve for the factory air conditioning. Do you have factory air? Is it the vacuum **** in the attached drawing?
-
no oil presure at idle
Sending unit is on the passenger (right) side of the engine block, down near the oil filter. Screws into the block.
-
Lead footed B's.
And none of the "beware for the children" warnings apply on a limited access highway. We've already discussed that the speed limits have different importances depending on whether you're on a surface street, in a neighborhood, or on the highway. It drives me nuts when people take a broad brush across an entire set of unrelated (or at least very different) situations and stamp them with some platitude. "There is no such thing as safe speeding" means nothing without context.
-
Lead footed B's.
Well, maybe I oversimplified my statements, and I only cited two different areas: city and highway, but that is what I was trying to get across. You're right that there are certainly different levels of "risk" even within the city. I don't want drivers blowing through my neighborhood at 40mph endangering the neighborhood kids, while on some of the main 4-lane roads through town, 40 is quite reasonable (even though the posted limit is 35). And I NEVER speed in school zones. So, as a refinement of what I had previously posted, I agree with you. Considerations of factors other than driver skill and car ablility are needed to set the safe limit. But I still think that the limits are set for the lowest common denominator for all the pertinent factors.
-
Lead footed B's.
I disagree. They set the speed limits at a speed for the lowest combination of driver skill and car ability. It is safe for grandma in her buick riviera boat. A skilled driver in a car that can handle transients would be just as safe at a significantly higher speed. A major risk factor on the roads however is speed differential. If grandma is doing 35 in a 45, and you want to speed and do 55, then the differential is 20mph, which gives you very little time to react to anything that grandma does as you try to pass or whatever. There is also a major difference between speeding on a limited access highway, and on a city surface street. There are so many more surprises waiting for you on the surface streets, and thus a safe speed will be much slower than on the limited access highway. One man's opinion...
-
Lead footed B's.
Interesting article. As always, it has its own slant, and uses the statistics for its own purposes, but makes many good points about probable government misuse of the same statistics. I've always been of the opinion that, within reason, the safest speed to drive is the speed you are comfortable driving at. I used to spend a lot of miles driving on the open freeways in the western US. I found that about 70mph was a comfortable speed for me then, even though the limit was 55mph. Note that the 55 mph limit in the US was implemented as a gas saving measure in the mid 1970's, and not originally for safety. Now that most speed limits on US highways are 65 or 70 mph, what speed do I drive on them? About 70 mph! That's the speed I'm comfortable driving on open, clear, dry highway, and thus I believe is the safest speed for me. I go slower when conditions warrent - weather, traffice density, etc. And I wholeheartedly agree with the paper's premise that the most dangerous drivers are the ones that go very fast OR very slow. The slower drivers are usually the ones that have no clue how to drive their vehicles in anything but a straight line, and thus under any kind of unusual condition, are much more likely to be involved in an accident. The extreme speeders, of course, can't avoid the accident because they are going so much faster than the prevailing traffic flow. Anyway, FWIW.
-
All right you lot, let's have you.
Doing your Leslie Nielson impression Bambi ???
-
I am now Z less
Lets see, the door post plate can be drilled out in minutes, and the engine bay one unscrewed in minutes. The dash VIN is harder to get to but just held in with two rivets. Probably have to remove the dash or the windshield to get to it. The hardest one is the engraved VIN on the firewall, but a grinder would take care of it in short order. That's to remove the VIN information. To actually get new info on the car would be a little harder, but the plates are just metal stampings.
-
Scary pics...
Wow. I too traveled that stretch many times when I lived north of Baltimore and had to go to DC often. That "random" element of life sure can be scary at times. I spent 15 years doing risk analysis of hazardous installations, and I can tell you that the probability of dieing like that is so small that you might as well not even consider it. But that doesn't help the people that did...
-
I am now Z less
Man that really bites. Sorry to hear it. When I lived in LA with my '75 280Z, all I lost was my stereo and a big chunk of the center console. Bummer.
-
Z newbie
Although I am not sure, I believe that the 5-speed was an option all the way up through '78, and the 4-speed was standard.
-
Z newbie
280Z's have a lot more stuff on them. BIG bumpers compared to the 240Z's. Beefier frame members mean more metal in the body. Beefed up doors to meet crash test specs. Mostly, the extra weight comes from Datsun having to meet US crash test specs, and somewhat from extra systems such as the FI, Cat converter (on some cars - my '78 is a CA car and has one), etc. I believe most of the extra weight will be from the bumpers, doors, frame, and generally beefier car. Look in the engine compartment of a 240, and you'll see a LOT more empty space than in a 280! If any of the racers out there have actual weights for these things...
-
Headliner fall out
Is it in a ZX? I looked at several ZX's before buying my 280Z, and almost all of them had a falling-out headliner!
-
240z restoration standards
If you read the judging criteria attached previously for the stock class, it says: FWIW.
-
240z restoration standards
To my knowledge, the answer is no. If you read the conversations we've had on this board (and on others), you'll see that there are many details that are unknown or debateable. In addition, for any single car, it is very difficult to know how it actually came off the factory floor, since Datsun apparently used parts as they had them, and thus the definitions of "Series I" or "Series 2" 240Z's as we use them in discussions are somewhat fluid for any specific car. Early parts can show up on slightly later cars if they were backstock that Datsun wanted to get rid of. Anyway, if you can find such a book, we'd all love to see it, I think. But I don't believe you will find it.
-
240z restoration standards
Perfect! thanks!
-
240z restoration standards
This raises a question that has occured to me as I work on my 240Z. If, say sometime in the future, I decide to enter my 240Z in a "Z contest" somewhere, and say I have gotten it back to as close to stock as I can, is there any place where I can get a "concourse checklist" or anything to know what judging would look for? I've heard of "290 point cars" and stuff like that - that's out of 300 points? Do the judges just look at the cars and try to find things that aren't "right", or do they have criteria? Given all our discussions about what is original and what is not, it seems to me that it would be very difficult to actually put together such a checklist. Anyway, anyone that has had experience having their Z judged in a stock class, I'd appreciate a little guidance. It's years of work before I get the car together, but it'd be good to have info now instead of after I've got it done. The more I think about it, the more I figure I'll have fun tricking up the 280 and taking the 240 back to what it was to begin with.
-
Steven Wright - the best of
Civ104, Been in HDG long? I lived in Bel Air from 1993 until 2001. I have a model of the HDG lighthouse sitting on my entertainment center. Nice area of the country.
-
round shape knobs and square shape knobs
Sweet! Yours is better than mine, since I bought one with square knobs! Anyway, on the firewall, there should be a pinch bracket to connect the cable through. I posted a pic of mine in another thread: http://www.classiczcars.com/forums/showthread.php?s=&threadid=8116&perpage=15&highlight=hand%20throttle&pagenumber=2 Look about half way down the second page of the thread, and I have a picture posted of the pinch bracket. I'm jealous now. I want round knobs! :mad:
-
Any ZX Fans
Will do, but don't hold your breath. I spent a couple months looking and watching, and ended up driving to Cincinnati to pick up the 280Z that I bought. California car that had been transplanted. Everything else I saw within 500 miles was a rust bucket or way over my budget (like that ZXR!).