sweatybetty

i bought them for a 72 240z

i thought the flag of france was all white..........

that looks sweet! is that single stage, or base-clear?

stand back, take a deep breath. it is only photobucket. it is only the internet. you CAN live without either.

not the door opener handle, the upper-most one that you would grab to pull the door closed

thank you

anyone know ho to get the chrome trim to snap in place on the door pulls?

last of the interior finished today. door panels in and kick plates on

i had to modify the striker to get he hatch to close all the way. do i have the latch mechanism on correctly, or does it go inside the hatch? thanks all sb

pictures

i have 2 factory type door seals came in a kit that i bought from msa. i did install 1 of them, but my door was hard to close, so i went with a different seal. msa lists them at $70 each. i would like $100 for the pair shipped in the lower 48. if you are interested i can post a picture thanks all sb

i did this trick on my jeep fender extensions. it looks good for a few months.

you need 3 things. air, fuel and fire

undercoating is WAY cheaper

after watching that video, i truly believe the phrase "there is a sucker born every minute"

ive never seen this site before. they have a lot of parts listed, but the prices are all over the board https://maseraticompound.com/collections/datsun-240z-parts

im seeing vertical defroster lines

my 2 cents. put on 3 coats of clear, that will give you plenty of room for cut and buff if you need it. nothing worse then cutting through to base-primer. it happens SO fast

new door seals that i bought from ? installed the drivers door seal and the door WOULD NOT CLOSE so, went to the local wrecking yard and found a kia sportage, bought the seals for $30, and they fit well, but not as nice as i want. so, i found these on ebay http://www.ebay.com/itm/15Ft-Car-Door-Trunk-Rubber-Seal-Edge-Strip-Trim-Soundproof-Moulding-All-Weather-/132232103180?hash=item1ec9a5c50c:g:T6YAAOSwFJBZSNtz&vxp=mtr#shpCntId ordered 2 -15 foot kits, and they arrived today. they fit well, but the only complaint is they have a strange odor that seems to be fading away. door closes nicely with a bit of force which i think should improve over time new seal on the left, kia on the right upper corner

mine is leaking so i need to know the plug size so i can get a new gasket thanks all sb

i remember mine being very tight as well, but they did go on

very nice. do they get glued on?

ironic that i was trying to adjusting my hood today also. i found this a few days ago

i would think that you would want to topcoat asap just to avoid any contaminants (dust etc) from getting on the base