nix240z

Few things in the works. Plus I have some other items in the works. Headlight wire end boot. 95% of these I have seen are rock hard and deformed. any interest in these? 240z turn signal mounting hardware. I needed a set since mine were rusted out. I machined the bolt down on my lathe. cut and bent mounting plate drilled hole tinned metal for soldering soldered bolt to mounting plate and then they will be zinc plated. Steve

Just looked at my 7/71 and they are there also. Steve

My bumpers came yesterday and look very nice. I test fit the front and rear bumper shims I have and they fit perfect on the brackets. Steve

Finished the rear strut cap. Exactly the same as Nissan. I'm also working on a few other items. The headlight wire plug socket boot. also the plastic pins that hold the fiberboard kick panels on the left and right side. Steve Nice tight fit.

$2.35 in Taylors SC

I just ordered a set also, with 15% off today.

It's hard enough making them in a mold, Steve

Looks great. I will be getting a set for sure, I just registered at their site. Steve

That happened to mine also, I just resoldered the joint. Steve

www.240zrubberparts.com in South Carolina.

I did the same thing, I have replated everything on my car. Then the rubber looked so bad, I reproduced many of the rubber parts and started www.240zrubberparts.com some pictures of my car and plated parts. The Link will not work on apple products, sorry. http://www.240zrubberparts.com/apps/photos/ steve

I am also working on the 240z rear interior strut cap, I should have a sample this week.

preview of the voltage regulator 6 prong plug protective boot.

Ok let me know when ready to order. Not much work on the car over the summer, making and selling parts takes up all my extra time. I have had over 16000 hits on the website and have filled over 100+ orders all over the world, thanks to all who have ordered parts from me. Steve

I have looked at the handbrake and it seems that the rubber is a different type than the urethane I use. I could do the Speedometer cable and hood opener cable grommet, I would just need a sample for correct measurements. I would also need a good sample of the Early 240Z wiper motor cover. Steve

I have been working on a few new items, one is the rubber seal for the antenna to rear quarter panel. The second item, which is still in the development stage, is the voltage regulator 6 prong connector protective boot, this one is gone 99% of the time. Picture of new boot coming later this week.

a few more pics, hope this also helps. Steve

That is some nice stuff, I agree pictures do not do them true justice. Steve

I used the tungsten steel solid carbide burr bits. Steve

I used a dremel with a small bit. Steve

They are not even sure what they need. Ie; Seats (maybe) steve

I have both types, the round early type and the later square type. check my webstore. steve

My 3.2l build took about 8 months on my Rebello. Dave always would keep me posted on the progress. Mine is still sitting in the shipping crate waiting for me to finish the car. Steve

I dont think it will come out. You will need to desolder the wire end and remove. Steve

I have added a few new items to webstore. Steve