Leaderboard
-
Patcon
Subscriber
2Points11,059Posts -
240260280z
Free Member2Points5,426Posts -
Mike
Administrator2Points23,055Posts -
grannyknot
Free Member1Points5,158Posts
Popular Content
Showing content with the highest reputation on 10/26/2015 in Posts
-
1 pointI didn't know Nissan even produced it, I went to our club's Fall swap meet and the Nissan dealership parts guy was selling it at his table. I might just hang it on the wall. All three Z's I have taken apart had serious rust on this piece. If you don't recognize it, it is the panel that the gas tank filler tube goes through. Chris
1 point -
A garret would shoot to the moon. I'm going for a red lion poop pusher.1 point
-
1 pointI love beer and steak is good too. I like road trips too. You never know... Looked it up. It's only 37 hours each way1 point
-
1 pointWow, who would have guessed that part was avail. Makes me wonder what else they still have that we don't know about. I think I'd invite the Nissan parts guy out for a few beers and pump him for info. That looks like a great pattern piece to me. Before you frame it, some detailed measurements could be useful in the future.1 point
-
1 pointI don't own any Clecos but they would work. The 1/4" zip screws like heating and air contractors use work great, are cheap, no predrilling and you end up with a small hole to fill either way. I use a magnetic 1/4" bit holder so it can be set with one hand, leaving the other hand free for panel placement. For what a few Clecos cost you could buy several hundred zip screws and the bit holder.1 point
-
1 pointWell, we got out to Jai's house again. To describe what went on is pretty lengthy, so I posted it over at my blog. If you're ready for a long, leisurely read, here it is: https://fiddlingwithzcars.wordpress.com/2015/10/24/friday-at-jais/.1 point
-
Finally drove my 72 since purchasing 3 years ago. Drove it ~ 140km.
1 point
