I am missing the nuts that secure the radio's front facia to the on-off/volume knob and the channel select knob.  Does anyone know the size and pitch of these nuts.

Thanks in advance for your assistance.

On 8/3/2020 at 10:04 AM, qz16 said:

I am missing the nuts that secure the radio's front facia to the on-off/volume knob and the channel select knob.  Does anyone know the size and pitch of these nuts.

Thanks in advance for your assistance.

I had the same issue for one of my Hitachi radios and ordered a pair from Wholesale Electronics, Inc. The nuts are 8MM and are made specifically for import radios.  www.weisd.com is located in Mitchell, SD. The 2 nuts were only 8-cents apiece and were the last 2 available. Hopefully, they have more now. The grand total with shipping was $10.06. 

Steve

Edited September 8, 20204 yr by lonetreesteve
Added picture

The correct nuts have centering bosses to align the face plate with the radio. Do the WE nuts have that feature? At least they do on the early AM only radio, I'm not sure if they are the same for the later AM/FM radios.

Edited September 8, 20204 yr by CanTechZ

You're going to make me go measure the threads aren't you? I can't stand not knowing....

All the nuts I've seen have the raised center. 

M8 x 0.75mm is the thread size. 

Edited September 9, 20204 yr by zKars

Thank you Steve, CanTech Z, and Jim.
regards,

ron

Best Google found outfit that might make them

https://www.henefelt.com/product-page/hex-panel-mounting-nuts/