az240z

take a look at the Kia Sportege blower motor. Mid 90's, You'll have to modify the housing some but other than that it is direct replacement.

Here in Arizona the upholstery guys use the blue label landau top glue. It has to diluted some and then sprayed on.

Pen??? whats a pen???:classic:

Thanks for the reply but I think your talking the vents in the heater box. I'm talking about the fresh air vents that bolt into the corners of the firewall. I didn't think to use vinyl, the only problem would using the right adhesive.

I am in the process of stripping and parting out a 1973 240z. I have the fresh air vents out and looking at the rubber damper I see, after 40 years, that the rubber is cracked and disintegrating. Wondering if anyone has refurbished these and what was used as replacement rubber. The material is very thin and goes onto a backing plate.

pm sent

check out this custom a/c:http://desertdatsuns.freeforums.org/1975-280z-a-c-project-t2294.html

rear bumper is staying home. Front bumper would be good for dd. Both doors are good, rear hatch is excellent, pax floor and frame rail or ok. I have all the interior vinyl which is in good condition. Gas tank is ok, probably needs to boiled. Alot of the small parts are available.

Thanks

I will be cutting up a 1973 240z and have someone interested in the rear quarter panels w/ wheel arches. Does anyone have any idea what the weight would be??

got some from my local glass shop. They fit perfect but were $30.00 each.

If you need another cover let me know.

zcars is correct as each year were different but almost all the connectors are the same. So you could do the job of rebuilding your harness using another harness. I bought 3 different harnesses just for this purpose. Although I never completely rebuilt a harness I had all the connectors to replace the ones that went bad.

try precision's web site. You should be able to do a search on their site. If you have Datsun part # you search using CarPartsManual.com

Just letting you know I have this available.

got the engine,tranny,fenders,front valance.rear hatch.rear bumper off the 73 240z that I'm parting out. Found very little rust.

Also it isn't that hard to take out the seat

you can't put a price on sentimental value. I like that you and your dad are going to review the needs of the car and then go from there.

Is there a chemical dip in your area? That would eat all the rust leaving you with seeing all that would need to be redone.

check out this discussion: http://desertdatsuns.freeforums.org/1975-280z-a-c-project-t2294.html

If the screws are rusted be very careful when putting back in. Had one twist off at the head with just minor turning. Went to Ace and got new screws. By the way new rubber is available from Nissan. Get the part# from http://www.carpartsmanual.com/

Good for her. She's a keeper

The best, if you can get a hold of him. I tried for over 3 months but to no avail.

Action Machine is used by most on Desert Datsuns. Their in Mesa.

the carb insulator spacer is available from Nissan.