Everything posted by Ron Carter
- blocked of antenna opening
- fuel cell bulkhead III
-
hole in roof to finish weld on roll cage
-
Well Cell installation
Thankyou for your complement, i have seen your photos of your fuel cell and they are quite impressive. Because I am building a replica of an early Z race car that had a well cell, I have decided to be accurate to the orginal car. We are in the process of fabricating the straps that will hold the cell in place and I will have additional photos in the near future to document this. The vent line will run out the side of the bulkhead and out through the tail light panel, the fuel lines will run out of the rear of the cell through the wheel well section. You cant really see it in these photos but the cell has a flat section at the back that allows plenty of room to run lines through.
-
bare metal...
-
front, after media blasting
-
interior after media blasting
-
after my car was media blasted
this is one of several photos after my car came back from the media blaster. I am very pleased that there is very little rust and no bondo!!
-
fuel cell bulkhead
this shows the cover (bulkhead) of my fuel cell, prior to the installation of a trap door for refueling.
-
Fuel cell installation II
-
Well Cell installation
- BRE Armada IIa
- BRE Armada
-
Street driven C-Production 240Z
-
fiberglass dash7
-
fiberglass dash6
-
fiberglass dash5
-
fiberglass dash4
our first customers fiberglass dash prior to install. Want one? Contact PDK Fabrication www.pdkfabrication.com
-
fiberglass dash3
-
fiberglass dash2
-
finished fiberglass dash
- VARA
-
14x8J & 14x11J
-
C_Mollett
-
240Z Racecar for sale
Eric, Sorry to hear about your maritial problems:( I was surprized to hear that you were getting out from under your Z. I understand that we all have to make sacrifices and with your current predicament, well.... selling your car might be a good idea. On a positive note, I have a good friend with a newer mustang convertable and it is a very pleasant car to drive. I am sure you will enjoy that car too... Best of luck. Ron:stupid: