Leaderboard

Templates for the tar mats (floor insulators) for the front floor and under seat areas of a 1970 240Z in PDF and DWG formats. The dimensions were taken from my July '70 car. I measured these as accurately as I could and printed verification templates on a wide format printer to check fit. Transmission tunnel and rear deck templates have now been added, this now a complete set.

Templates and a 3D model (.stp format) for a 240Z glove box. the main formed body and flat sides were checked against disassembled and flattened original parts and are quite accurate. The smaller formed corner parts are not as accurate. Also included is a 1:1 scan of a tracing for the two formed corner parts, these parts were only roughly modelled and did not flatten exactly the same as the actual parts.