Leaderboard
-
Captain Obvious
Free Member3Points9,928Posts -
borini63
Free Member3Points456Posts -
Patcon
Subscriber
1Points10,996Posts -
grannyknot
Free Member1Points5,158Posts
Popular Content
Showing content with the highest reputation on 03/25/2018 in Posts
-
Well, total cost was $0 so I’d say it came out looking ok. Just need to give it a good polish and get some heat resistant material for the underside.
1 point -
1 point
-
1 point
-
1 pointWell that is better than the guy I know who painted absolutely everything in the engine bay white, everything, one trick pony. Yeah bead blast will have that nice and clean in no time.1 point
-
1 pointSome paint stripper and some carb cleaner and it might clean up. Carb cleaner will take off most un-catalysed paints. Bead blast after that, if you can, and pretend it never happened...1 point
-
1 pointLOL! I opened the thread at the newest post (yours above) and that way I don't have to punish myself with that pic again. The methylene chloride based paint removers will eat anything the PO put on there. Even if it's powder coat. Of course, bead blasting would probably be faster.1 point
-
1 pointEwwwww. I'm really sorry, but I'm not going to open this post ever again. Not even the tastefully done artful presentation make that thing pretty!1 point
-
1 point
-
1 pointIt's been a while science I last posted in here.... Just mounted a new Steering wheel with a New shift Knob(been made by my friend Max Sitti) and matches the original shift knob. I need to get a Blue stitched Shift boot so I can match the steering wheel blue S emblem, shift knob and the shift boot. The Red colored emblem and shift knob tag are for the almighty GTR.
1 point
