35 minutes ago, Yarb said:

I understand that, AI is a smorgasbord of articles massaged into one

I almost made a comment about AI. It's basically a better Google search. But that's about it.

23 minutes ago, Toiletduck34 said:

, the injectors are all functioning and sensors because its stopping after a running for ~9 seconds

The engine can run off puddled fuel in the intake manifold. If the injectors were opening the engine would continue to run. cgcheen's suggestion about testing with a 9 volt battery was a good one. You can run separate jumper wires if you don't have an EV1 connector. With a 9 volt alkaline battery you don't have to worry about melting wires if you accidentally short them. You'll hear a click when you connect the 9 volts, if they're opening. Also, with 9 volts you can leave the voltage connected while you tap them. You'll have the solenoid pulling them open if you can get them to break loose.

Pin 1 at the ECU is the ignition signal that the ECU uses to monitor engine RPM. It's connected to the negative terminal of the coil. It should read battery voltage with the key on. But it also needs a certain type of voltage pulse. There are things that can screw it up.

You're making great progress.

I’ve mentioned it some many times in the past about replacing each and every connector on the EFI harness and cleaning each connection in that arena. You will be amazed at the corrosion that you find on each connector and the wire itself. I had to shorten some wire by over an inch before I could find wiring that was suitable to crimp/solder.

9 minutes ago, Zed Head said:

The engine can run off puddled fuel in the intake manifold. If the injectors were opening the engine would continue to run. cgcheen's suggestion about testing with a 9 volt battery was a good one. You can run separate jumper wires if you don't have an EV1 connector. With a 9 volt alkaline battery you don't have to worry about melting wires if you accidentally short them. You'll hear a click when you connect the 9 volts, if they're opening. Also, with 9 volts you can leave the voltage connected while you tap them. You'll have the solenoid pulling them open if you can get them to break loose.

Pin 1 at the ECU is the ignition signal that the ECU uses to monitor engine RPM. It's connected to the negative terminal of the coil. It should read battery voltage with the key on. But it also needs a certain type of voltage pulse. There are things that can screw it up.

You're making great progress.

That makes sense, I already testedt all the ECU pins and were reading correctly... The only thing left is the AFM which would also make sense why the injectors wouldnt firing. I tested each injector and they are functioning.

I have stopped testing for the night because i broke a fuel line that was very old. will need to replace that before messing with the AFM. but i dont think im getting good signal from the AFM to the ecu. thank you for your help everyone.

Here is a way to test the function of the injectors separately from the ECU. With the ECU connector removed from the ECU, turn the key on. Then short the pins in the ECU connector from the injectors to ground with a quick tap. Each tap should produce a click frm the relevant injector. You'll need a quiet garage or a friend in the engine bay to hear them. Or a long wire.

6 minutes ago, Toiletduck34 said:

I have stopped testing for the night because i broke a fuel line that was very old.

If you do get the engine running well, replace all of the old fuel lines on the rail and the injectors before too much driving. I smelled gasoline on mine one day while driving and when I opened the hood a tiny stream of gasoline shot by me on to the sidewalk. They dry out and crack lengthwise.

The small stuff will eat up a lot of your time but it's worth it once you're done.

Edited 1 hour ago1 hr by Zed Head