It'll end up in a container bound for Kuwait

Do a quick ring around Menzies Metals and other Bulk Metal merchanants just in chase someone saw it there and traded it for a quick $300 worth of steel. You never know. Ring up some local car collectors and find out where they take the cars for recycling.

Good luck & be Quick !!!

Do a quick ring around Menzies Metals and other Bulk Metal merchanants just in chase someone saw it there and traded it for a quick $300 worth of steel. You never know. Ring up some local car collectors and find out where they take the cars for recycling.

Good luck & be Quick !!!

My new number plates "QWIK"

go do some work kid k

Sometimes play is more important than work!

Did a qwik check of trims, I think I have: 2 rear trims, a boot trim ( could be short some clips ), and a rear bar! Let me know if your interested ( Location Melbourne)

that sux bout the car :<

also s13drifter i may have some 4door stuff but it may not be the best condition :<

i know ppl with a few spares so i may be able to swing something

Sometimes play is more important than work!

sometimes?

mate... play is ALWAYS more important than work...

you need to run a 2.5mm tip and needle kit in your gun, Dave ( my brother) says he ran our gun at 40-45 psi. Again we used the same epoxy thinned down as an etch........

What brand and type of epoxy and hi fill did you use? can i also ask.. when you epoxied the car, how did the paint look immediately after spraying?

I just sprayed my bonnet and bootlid with Dupont 840R the week before last.. but i don't think i had the gun set properly.. i expected the epoxy to look shiny and almost like a plastic coat.. but instead it looks more like a primer out of a can (i think i had the fluid down too much and it dried before hitting the paint)

i am trying to work out if the epoxy should look like a wet pool when applying

The House of Kolor, and PPG epoxy primers both come out matt like normal primers, once dry. I have seen the shinny primers, they are gaining popularity as you can see dents easier but dont assume because its epoxy it will be shinny. When applying; primers are shinny then they dry matt, id say you where to dry on the coats if you couldnt achieve a wet look before the paint flashed and dried.

Cheers

Edited August 29, 200916 yr by s13drifter

Definately interested in the trims, I have a good mate in Dandenong that you can send the parts to, Trevor Davis auto refinishers, will get a street address we can work out something for sure as someone is down there every few weeks as Trev paints all our rods and cars.

no worries, just let me know.....do you have any more pics of the orange coupe, where, what, who