Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 03/14/2015 in Posts

  1. I let her see some sunshine today. Took her to RallyeSport here in Denver to get the carbs properly tuned for the elevation. He's also going to dyno it so I will have some wheel hp numbers. Next stop is the body shop to have the hood and fenders installed and aligned.
  2. Oh no I swapped an L28 into my 260z, but kept it carbed for simplicity sake. So I had a bunch of FI stuff to get rid of. My car has a heat shield, and round top SUs :-)
  3. SOLD $230K or $253K with buyer's premium
  4. Checked the AAR and the fuel relay. All is good there and the pump circuit is energized. Either the wiring harness or the pump is the issue at this point. I had to stop where I was as I had some company 'helping' me today... my grandson! Say hello to Ryker!
  5. Just thought I would let everyone know who is still having "hard to close" door issues, that I gave the "glued" rubber method a shot last sunday when I was pulling my hair out trying to adjust my latches and not having any luck. Works like a charm! I happened to have a small section of 1/4 inch fuel line laying on the garage floor while searching the forums Sunday for a fix for the latch, and thought what the hell, lets try using a small section of this fuel line....couldnt hurt to try it right? I grabbed my wire cutter , eyeballed the size I needed...about 3/16 ish, sniped off a piece of the fuel line, then cut it so I could slide it over the lobe of the latch and presto! the door closes so easy now!! so give it a try if you have the problem....
  6. Ordered main bearings, rod bearings, front and rear seals, freeze caps for a new motor build... finally some work on old blue after 8 years!
  7. Test trim.61E8C9EC-FCAA-401C-BA48-83E34894353F.MOV
  8. 1 point
    bhermes, In looking at the pictures of your tank, your float appears to be turned 90 degrees to the way mine was laying on the bottom of my tank assuming your two pictures showing the float are upside down as I am perceiving them to be. Your tank looks different than mine so maybe your sending unit is supposed to look that way. Anyone know if some Z car tank floats rest an end on the bottom of the tank as bhermes' gas tank pictures in post #44 seems to be showing?
Remove Ads

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.