Ventura usually Oxnard though, but I'm down in Vegas for awhile now.

I lived in Ventura for a while on Seaward Avenue. C-Street was my fav place to surf as well as points north. Carpenteria was for those special days in the middle of the week. When I get Project 3/72 finished I plan to take a long road trip with one of my sons to let them see what SoCal looks like.

On 1/9/2012 at 10:03 AM, Bonzi Lon said:

The crank snout bolt is 27mm or 1 1/16 inch.

Bonzi Lon

Early engines in 1969 had 24mm crank bolt

Well I guess I’ve been doing this wrong then. The two times I’ve done I’ve turned it by the cam bolt since I can’t get a socket on the crank without removing the rad (aftermarket). So far I’ve had no issues doing this with timing or issues with the engine but good to know