I have been looking for some natural finished Watanabe's for my 260z. I wanted 15 by 7j. How would these fit on my car? Would the tires stick out of the wheel wells? Do I have to get special lugnuts for them? If so, how hard are the lugs to find. Thank you.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=43955&item=2426679735

-Ben

Where's the dish????

I know. I am looking at them and the more I look at them the more I don't like them. I would like that dish look too. Thanks for reafirming that.

to use them without spacers and also as previously mentioned, no dist look to them.

eh they are nice but i would pass

Nice for a 240SX but no good for a Z... You'd have to run some very thick spacers and then you still might have problems with spring clearance... then you would be spending even more on adjustable coil-overs...

Best to find some with the right backspacing.

Thanks guys. I feel a little dumb because I am interested in purchasing a set of wheels in the near future, but all I know is that the pcd has to be 114.3 by 4.

Here is a newbie question. To get that dish look, what width, diameter, offset, and backspacing should I look for? I do not want to flare or install spacers. Thanks again. Sorry, I know I have been bugging everyone about wats. :stupid:

Here is a pic of the deep dish look that I am going for. I would like those wheels too.

http://www.rs-watanabe.co.jp/images/users_photo/z_gin.jpg

!!!