I'm thinking you need to remove the heat riser to install the 6to1 and the carb heat shields.

Edited March 12, 20224 yr by siteunseen

I have headers on mine.  I must say that I haven't tried to hard to put in place yet.  When I bought the header, I really didn't put much thought into which one to buy.  I wish I would have don'e a bit more homework.

Is it safe to assume that I don't want the heat shield touching the header after it's installed?

 

See if you can bend the heat shield a bit to clear the header and yes, ideally you want an air gap between the header and shield. Also, the heat shield is typically the mounting point for the carb return springs.

I think it would make an annoying sound if it touches? Try bending like Mr Arnett says but on my 280's 6to1 I had to Dremel the vertical shield to fit. Also the transmission. The header barely made contact and I hate hearing things that don't belong.

 

I'll try tweaking the heat shield a bit and report back.  

Regarding the return springs, I have them rigged with a piece of wire to put tension on them.  It would definitely make my life easier if I can get the heat shield corrected.

Edited March 12, 20224 yr by HappyZ

You can figure it out. We'll be here for any ideas thay maybe helpful if you ask.

I've put headers on all my Zs and was always able to figure something out.