For all those with the original style paper/cardboard glove box insert (left image) in their 240z, I found a cheap and easy way to upgrade to a plastic insert from a later 280z (right image).  I picked my used 280z insert up for $10 on ebay a while back.

   
Here is the picture of what I started with.  A huge cut in the back of my cardboard insert from the prior owner.  Its only gotten bigger since I've owned the car

Old and new side by side.  The 280z plastic insert will need to be trimmed to fit.

 




There are various approaches, I chose to trim just the bottom tab and the made a new hole for the glove box door arm

The finished product is much nicer than what I had in there originally.  I did need to mount the glove box door first and then slide the new insert in.  I also put screws into these front holes to hold it better.  I probably could have trimmed down the side tabs as well and use the original holes, but this seemed like a much more secure way of mounting the insert.  I will probably look to finish the bottom edge better and possibly heat the plastic to shape it better.

This post has been promoted to an article

Moving this to the technical articles area.  Thanks for sharing!

That is an awesome upgrade!  I was actually thinking about something like this so I'm going to try it as well.  My original glove box crumbled when I was removing it.

Speaking of the origional glove box insert. Mine has been removed so long I cannot remember if it gets reinstalled from the front or the back.

How did yours come out? Front or rear?

I pulled my original cardboard out from the front, same for inserting the new

Sent from my iPhone using Classic Zcar Club