I purchased a set of these from Banzai Motorworks for my '71 (see first picture below). I did a search here Classic Zcar Club, but could only find a picture of an old used one barely hanging on with the door weatherstrip pulled out (see 2nd picture and link to Bre-240Z's thread below). Does anyone have a picture showing a new one fully installed?

http://www.classiczcars.com/forums/showthread.php?p=242346&highlight=quarter+window#post242346

hmm, well i could take a pic of my 260 one installed but it is a 2/2 and so different design. not sure it would help. my original was a single piece, but the replacement is not.

I purchased a set of these from Banzai Motorworks for my '71 (see first picture below). I did a search here Classic Zcar Club, but could only find a picture of an old used one barely hanging on with the door weatherstrip pulled out (see 2nd picture and link to Bre-240Z's thread below). Does anyone have a picture showing a new one fully installed?

http://www.classiczcars.com/forums/showthread.php?p=242346&highlight=quarter+window#post242346

MSA has them for $9.99 each (ouch!)

How does this seal install on the car? Pictures?

Thanks

Miles

Bump looking for the same answer orva installed pic

Thanks, Blue! I still haven't installed the pieces yet, as my project has been a slow process. However, I plan to have the car completed and on the road in June.

Thanks again, this helps me.

Frankly I think the whole design for this seal and the one at the top (that you can't get anywhere), is pretty lame. They should have covered the entire front edge with a seal from the start, like they did later.