Hey all, I got these wonderful instructions from a very nice guy on ebay when I bought a harness from him a while back. I was wondering if anyone needed a copy they are very thorough and give a detailed list of parts needed , replacement parts, breakdown of the distributor and trouble shooting for the distributor as well as the tach. These are for the install of the stand alone ignition from later z. Its in a acrobat format, 10 pages long and is about 1.5 meg if I am correct. Just pm with your email address and I will be glad to send them. Thanks all

for those on dial up it might take a bit it takes me 20-30 second to upload with cable , good luck

I can also rescan the instructions sheet by sheet if that is needed as well, that way it might be easier instead of one big file, Jeff

alordzot@hotmail.com thanks I was looking for som guideance.

for those on dial up it might take a bit it takes me 20-30 second to upload with cable , good luck

On my Dial up it took only about 5 minutes. No big deal.

good to hear , was sure

Hey all, I got these wonderful instructions from a very nice guy on ebay when I bought a harness from him a while back

Was it Gary Boone?

Honestly don't recall , I was under the impression he dealt more with the fairladys <small convertables> more than the z cars , but he rebuild the distributors as well.

would like a copy as well if you dont mind

rob@labelpower.com.au

Cheers!

donnie@portal.com...Thanks!!

Got a copy last night from Jeff, very good and thorough instructions for doing the swap! Nice one Jeff

Cheers,

Rob

I would like a copy as well

kwarrenh@bigpond.net.au

Thanks