Search the Community
Showing results for tags 'broken'.
Found 1 result
Trying to remove the head of my n42/n42 the bolt circled in green snapped on me with one thread showing on the piece removed. Which means it should be below the block surface and not preventing me from removing the head, right? The bolt with the blue arrow felt as though it was cross threaded all the way in, and now that I have it backed out as far as it will go it just continues to spin. Ive tried prying up on it while turning it, ive tried tightening it again, ive tried beating on it in frustration...right now I have vice grips on it trying to pull it out. I dont know if they put a long bolt in a short hole and it mushroomed out on thebottom and is preventing me from getting the head off or what. I have hit it with a rubber mallet and have a pry bar wrapped in paper towels inserted in the intake port trying to yank on it, but the darn thing wont budge. And yes, I have removed the two head to front cover bolts. Does anyone have any helpful advice?