Fuel sending/fuel pump wiring harness grommet, located in the right rear hatch area.

Steve,

Is this the grommet that protects the sending unit wire harness where it passes throught the rear deck floor? If so, I'll add it to my llist.

Dan

Steve,

Is this the grommet that protects the sending unit wire harness where it passes throught the rear deck floor? If so, I'll add it to my llist.

Dan

yes...

Antenna Drain tube grommet, located left rear wheel well area.

Speedometer cable grommet on firewall. Will need to be cut and glued back together, I machined so it has some meat in the center for easy gluing, plus hole in firewall will help hold it together. No other way around this, since ends of speedo cable are large and will not come off.

I will list on website when ready for purchase.

240zrubberparts.com

another NLA part.

I had a few request for this part. Any other interest in the dust boot for the handbrake in the transmission tunnel? I machined up the part and ready to mold and cast.

leftside is the machined part and rightside is the original.

Steve

This is a part I was going to ask about. You are on it. I have to check out your website.

another NLA part.

I had a few request for this part. Any other interest in the dust boot for the handbrake in the transmission tunnel? I machined up the part and ready to mold and cast.

leftside is the machined part and rightside is the original.

[ATTACH=CONFIG]69037[/ATTACH]

Steve

I need a set of seals for factory headlight covers. I can get a set of originals to copy.

STeve,

Do you have an illustration of where this handbrake dust boot is mounted? I couldn't find a part number or reference on my parts CD. On my last fun drive,

I did notice a cool breeze of air coming from the handbrake boot, but couldn't determine the source. This probably going to be added to my shopping list.

Dan

Sorry I dont think I can help you out on these.

I need a set of seals for factory headlight covers. I can get a set of originals to copy.

Dan, it is the circled part..

STeve,

Do you have an illustration of where this handbrake dust boot is mounted? I couldn't find a part number or reference on my parts CD. On my last fun drive,

I did notice a cool breeze of air coming from the handbrake boot, but couldn't determine the source. This probably going to be added to my shopping list.

Dan

update on the firewall speedocable grommet. The grommet is done and I am testing the glue to hold it together after cutting. Regular superglue works fine, I have the grommet glued back together and under a stretch test of 150% of the cable size, to see if it comes apart. I have also ordered some loctite 406 which is made for rubber and high heat. Once I complete the tests I will report my findings.

Steve

Edited January 10, 201412 yr by nix240z

update on the firewall speedocable grommet. The grommet is done and I am testing the glue to hold it together after cutting. Regular superglue works fine, I have the grommet glued back together and under a stretch test of 150% of the cable size, to see if it comes apart. I have also ordered some loctite 406 which is made for rubber and high heat. Once I complete the tests I will report my findings.

[ATTACH=CONFIG]69066[/ATTACH]

Steve

Love the R&D. 150% is a tough test.

Chas