Datsun competition bucket
By v12horse
- 8,319 views
- View v12horse's images
This is the Datsun Competition bucket (U0175, thanks for the number Alan and Chris) that I believe was offered only for the drivers seat in the 432R. This seat appears to have a different headrest mount than ones I have seen. As you can see, the headrest is missing. This was also the seat of choice by Nissan for their works race cars. If anyone could bring some light to this seat it would be great.
-
Gallery Statistics
-
-
Image Comments
-
I know a few people were following along on this- been a while since I last posted here- but finally all came together!
Mounted up and running strong! Still a few details to work out; but runs good, sounds good, feels good on the initial pulls. Super happy it worked out!
-
-
Well I decided to go for it -
Went with 42's and a TWM manifold. Still lots to sort out, but Ill start another thread on it somewhere and link it back here. Rought calculations hopefully put it in between an OER setup and a Mikuni PHH setup $wise.
-
By duffymahoney · Posted
I would probably do them in pairs, then each pair goes to a common shaft.
-
Part of running a single shared throttle shaft was for a super clean look- like how datsun_tokyo linked above has it.
I also still haven’t decided on the manifold- but was planning on the TWM one- seems to be the cleanest and allows me to run without all the linkages.
With that said I’m interested- I’ll shoot you PM.
-
