Prob been covered before, I searched found some old data.

I keep putting off doing my trans swap (rear main, clutch, trans swap 5 for a 4 speed) due to fear of the unknown.

anyway looking for good shop that knows how to work on old Z's (1975 280z). Found a website for Z tech in longwood FL.

any others, looking for feed back on Z tech or other shops for this kind of work.

Dave, post a link.  The Z tech I remembered is long gone and was in College Park. 

 

http://www.ztechorlandofl.com/

spoke to Avi (sp?) still there.

He said bring the car by during the week, with the transmission to discuss.

Edited March 3, 20179 yr by Dave WM

Interesting. When you go ask them if they used to be in College Park.


Sent from my iPhone using Classic Zcar Club mobile

been in bus since 1980 looks like, he is the owner. I will drive by and talk see how it goes. I don't mind paying as long as I know its done right.

Hey Dave if you go will you ask if they have a paint and body guy they would recommend.


Sent from my iPhone using Classic Zcar Club mobile

will do, plan to go some time next week. I attempted to get started on the trans swap, car on jacks, penetrating oil on exhaust studs (remove exhaust pipe for access) impact gun, promptly snap off nut.... enough of that I will take it in and see what its going to cost. I prob should have heated with oxy/ace torch, all I had was a propane, not hot enough i guess. Anyway enough of that.

I will check them out and let you know. I would have thought there would be more folks here that have used them.

Plan B go to a local muffler shop to see what they would charge to loosen up those done pipe nuts, and get the snapped on out.