Thank you :laugh:

Looks WAY different

even wondered why did nissan make so

So I'm gonna leave it all as it looks now

Made inner arc

Looks great.

Hopefully my picture wasn't confusing because it should be turned 90 degrees counterclockwise to be correct. I had cropped it and the upload process turns it sideways if the picture is too tall apparently. I didn't know that might happen.

Ahahah that's hilarious xD

I could guess but I didn't expect the picture to be turned...I thought something is strange,thought you have given a photo of right side,also I had this http://becksystems.com/KellyW/025KellyW.jpg but didn't notice

and now I have that feel when you realize that everything is much easier than you thought.

Wish will post update on sunday,also will create threads on 3D forums,but still have not got enough of the model done.

I think about reorganizing my time to have more time for the car,not to make the work very long.

Made the holes,made the thing on 3 picture(hehe don't know how to call it,I think this makes roof harder),also fixed and chamfered the hole for extra wheel

added details

started to make tail lights space

You have come a long way on this drawing.

You have come a long way on this drawing.

50 hours of work by the previous update

Here's a couple of photos I have of my '72 z's rear interior without vinyl.

Thank you ironhelix,very good photos!

Here are a couple of pictures of the rail width at the side of the hatch. Note that the part of the rail towards the side of the car is chamfered, the side towards the interior of the hatch opening is much more straight. Hope this is an area you asked about in the PM you sent me. I don't have a way of putting pictures in a PM because I don't use a picture hosting service.

Same area zoomed out:

Edited October 5, 201213 yr by Mikes Z car

Made tail gate space,moderately fixed the rail from tail gate to the roof and space around it(picture 1)

Aslo fixed chamfer and geometry inside