buying flares, grill etc

[240K&Beyond]

DO you have a picture of the light surrounds? Is it the black and crome part you are thinking of? Or the beaver panel itself? If its the crome bits, then we would have to find both sides to make a mould with mounting points. Does it look like any parts in the pitcure?

Edited July 29, 2009 by 240K&Beyond
spelling

[Mr Camouflage]

Add a set of flairs to my list, pending prices.

[240K&Beyond]

Guys don't forget to add your location when you want something. I will tlk to the bloke about postage as well. That way we can work out whether it's easier for him to do it or a local club freind.

[Disco Bob]

like this one,(outer stop/tail)

you only need one side as both part numbers the same.

Edited July 31, 2009 by Disco Bob

[khughes]

i would be very keen on a set of the tail light surrounds too it is the last remaining item on my GT-R shopping list

I attempted to buy a few when i had a contact in japan, but i always fell short, even around the $1250 mark! (probably a good thing though.. it was impulsive at the time, and needless to say a waste of money for a bit of plastic)

Perhaps somebody could replicate them from a photo (maybe in clay or something to take a mould from?)? the mounts etc are all the same as the non-GTR..

anyone got any ideas?

[KID-K]

Hi..guys..Adam off this forum has a set of cook top tail lights, I spoke to him if i could borrow them to make a cast, we'll meet soon to start casting...Also I'm in the process off making the fuel filler caps, I should have about 6 sets in about a week. I'm also running a trial on 240k gt interior badges...I'll keep everyone updated....keep an eye on Operation 240k for pictures regarding new items..........if anyone is interested i can also get the front air dam scoops made in aluminum!!!!!!!

[khughes]

definately put me down for a set of the tail light surrounds

pm me when you have an idea on price etc. and i will send you a deposit!

Edited August 5, 2009 by khughes

[khughes]

out of interest, what process are you using to make these?

[KID-K]

I was hoping to cast them in two pieces, front and back, then glue them together, I'm not sure how thick the lenses covers are, this would determine whether I use glass or resign.:stupid:

[240K&Beyond]

Hi Guys,

Ben came back with an offer regarding the bits. He will make the mould and pay for the freight for anyone suppling the parts to make the moulds from. Here is his starting prices:

flares - $220

grill - $200

Bob tail - $120

Front Apron - $80

The grill would be without the steel backing.

Your thoughts?

[Disco Bob]

I was hoping to cast them in two pieces, front and back, then glue them together, I'm not sure how thick the lenses covers are, this would determine whether I use glass or resign.:stupid:

Are you planning on making the surround and lens?

[Noddle]

Hi Guys,

Ben came back with an offer regarding the bits. He will make the mould and pay for the freight for anyone suppling the parts to make the moulds from. Here is his starting prices:

flares - $220

grill - $200

Bob tail - $120

Front Apron - $80

The grill would be without the steel backing.

Your thoughts?

Sounds fair enough, but I would think some one would need to uploads some pictures of a complete grill to show how the mesh is attached

Nigel