Needed to cut holes for the Go Pedal, And a few for the screws under the center console, and also 2 slits cut out to fit around part of the air box i think, And Cut all the underlay, but that may be because i just brought a roll of underlay,

Pics!!!

sorry for the poor quality, my flood lights were missing but u should get the idea:

just as a record, someone on SAU has confirmed via a magazine that the C110 and C210 share the same floor pan (well.. as confirmed as much as you can trust a magazine )

"Bought a motoring mag of EBAY, of course it had info about C210"s. It states that the C210 and 240k share the same floor pan.This was something I was wondering about a month ago due to recarpeting.

just thouhgt I'd share this snippet of info."

http://www.skylinesaustralia.com/forums/Floor-Pan-t227732.html

update on this fromt the same thread:

Today I ordered a moulded carpet from Tru fit. I explained about the 240K and the C210 floor pan being similar as read in an article I recently read. A few hours later I got a call back from Tru fit, much appreciated, anyway the chap had gone out and compared the 2 moulds. the findings: Same dimensions, except for a small difference around where the front seats bolt in, and a few cut aways ( holes).

oh and just got an email back from tru-fit.. They do still have the capret moulds for the C110 coupe

i got my carpet for my '77 240k through Knox auto carpets on ebay, Burgandy plush, looks great. Gave it a quick size up, seems like a good fit(yet to know as my car is under full custom restoration).

best of all, it was only $140+ postage for front and rear

fits great, looks pretty trick

Edited May 10, 201016 yr by 24TKman

I made my own, cost $30 + about 40 minutes

http://noddle.110mb.com/My%20Datsun%20240K%20Coupe%20-%20KHGC110/Carpet/slides/100_9220-2304.html

Nigel

Edited May 11, 201016 yr by Noddle

not bad at all.... how did you mould it to sit over the trans tunnel and all the corners??

not bad at all.... how did you mould it to sit over the trans tunnel and all the corners??

I used the original carpet as a template to cut this from,

over the smaller end of the tunnel (front half of car), it's a little lose (to much carpet), but the console covers it, so you dont see it.

it fits nicely over the wider part of the tunnel (front of front half).

Nigel