Littlered - Classic Z Car Club Skip to content

Littlered

Community Member
  • Joined

  • Last visited

  1. So did you have trouble with getting the timing set while installing?
  2. I ran a seperate relay with power trigger to make sure I had full battery voltage when key is in run and crank position to bypass the old ignition module and wiring. The old stuff has been disconnected. Yes I did have it running properly but the wiring going to the old distributor had been spliced in multiple places and I thought this system sounded like the right replacement. I used the timing curve 123 recommended. 15.8 up to 21.6 at 2,100 rpm and it steps up from there.
  3. I have 76 Datsun 280z that has been switched to Holley 390cfm 4bbl. I purchased a new Bluetooth 123 distributor and installed and wired it according to instructions. It will start but backfires and runs erratic if you bring the Rpm up. I’ve seen several you tube videos of the exact same problem but have not seen any on what to do to fix the issue. Any ideas out there?

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.