Jlar
Community Member
-
Joined
-
Last visited
-
Just checked them out. Going to look into them some more. Thanks
-
Looking to build my 1980 280zx engine. Engine is already pulled and has a N42 block and N47 head. I’m looking to bring the compression up and run a little hotter cam. I plan on it being out for a minute at taking time on it. What I has looking at doing to it. • 40 dcoe triple webbers • port and polish heads • cam with heavier springs ( new lash pads, rocker arms ext.) Lift(In/Ex): .480/.480 Duration(In/Ex): 274/274 • header to 2.5 in exhaust Not sure if going with 87mm flat to pistons to get compression to 9.9:1or milling the head .8mm would be better to get the compression up near 10.1 would be better Any experience in doing this or info I’m missing is helpful. Thanks in advance
-
Looking to build my 1980 280zx engine. Engine is already pulled and has a N42 block and N47 head. I’m looking to bring the compression up and run a little hotter cam. I plan on it being out for a minute at taking time on it. What I has looking at doing to it. • 40 dcoe triple webbers • port and polish heads • cam with heavier springs ( new lash pads, rocker arms ext.) Lift(In/Ex): .480/.480 Duration(In/Ex): 274/274 • header to 2.5 in exhaust Not sure if going with 87mm flat to pistons to get compression to 9.9:1or milling the head .8mm would be better to get the compression up near 10.1 would be better Any experience in doing this or info I’m missing is helpful. Thanks in advance
-
Yes I’ve had some engines apart. I’m looking to put some time and money into the car and im going to be pulling the engine this weekend. It’s a 1980 280zx with a L28e in it. It’s not running right now the injectors are clogged but I’m getting fuel to the rail. The car was in a barn for 20 years
-
Hey I’m looking to build my N/A L28 a bit. I’m not looking to go to crazy with it right now it was my grandfathers car so I’m looking to keep the same engine in it. Some things I was looking into • triple webbers • ported and polished head and new springs • flat top pistons • street cam shaft Any experience and help is appreciated thank
