Onion

That's a cool alternative. Did you move the existing baffle? I can't remember offhand if it extends that far down the side..?

Lumens- Great supplier...but nothing in the way of bilok adapters unfortunately... FYI, I usually sort my AN fittings/hosing from one of these places (in no particular order)- http://www.anfittingsdirect.com/ https://www.anplumbing.com/ JEGs Summit Racing Amazon Local (Austin) speed shop Usually atleast one of them has what I need with the exception of this bilok conundrum. I'm sure there are many other great suppliers...I've just been using these for my two Z project cars.

zKars- It did illuminate several suppliers but nothing with a conversion to an AN-fitting. This site in particular seems to offer a female bilok to male AN - opposite of what I need...which disheartened me: http://www.tubefittings.biz They do have a male bilok to NPT that I was seriously considering which is on this page on that site: http://www.tubefittings.biz/dlf.shtml I actually fired off an email to them earlier this morning inquiring about options...and may end up giving them a call later once I have a few minutes. I'll update the thread with anything I find. Mike W- lol, it's funny that you responded on this thread (thanks btw)! I didn't realize you didn't know my nick on here! Anyhow, the 1/2 NPT tap and drill is what I may end up doing. I do really like the rear relocation though...those pictures don't do it justice. Seeing it in person is pretty schweet. I do still want to pursue the relocation but was thinking about saving that for another iteration...either way, that solution is my end goal at some point...it's just too clean.

Mark- I did try McMaster-Carr and this sadly was one of the times that that amazing site has let me down...and I say that because I've lost hours perusing that place! ZKars- I was considering actually drilling/tapping a proper NPT fitting but was hoping for the necessary elbow already in existence before going down that road. I would rather not weld or tap onto the stock elbow. I appreciate the suggestion though!

From what i understand in my searches, the thread for the valve cover breather is a bilok 1/2 NPT. Does anyone know where to source fittings for this? I'm looking to obtain a right-angle to 8AN fitting. Thanks!