daddz
Community Member
-
Joined
-
Last visited
Everything posted by daddz
-
A recent shot of the '86 300ZX.1 hardtop -
Another shot of the '78 280Z. -
Another shot of the newly instaled fender for the 280Z. -
I haven't owned a 240Z for any length of time but with the 280Z....the worst design award has to be the damned HVAC system. The magnetic solenoids placed on the passenger strut tower and then the ignorant routing of all of those vacuum lines coupled with the infitely more durable heater cables. What a mess. I am about two minutes away from removing all of that sh** and replacing it with a vintage air system. If you are lucky you own a non-factory A/C car without all of those assinine vacuum lines and vacuum pods under the dash.
-
That is wonderful! I am smitten by TML-280S if you remember that car. It is also a maroon 260Z and thought to be registered in 1979 as well. It was on ebay last year and I never got a repsonse from the seller as to its disposition. If I get a chance to visit Great Britiain again I must be sure to give you a call. -
The new (used) fender. I will have to take a better picture in the daylight. -
This is between coats just before installing the blue fender. -
This is after the first coat of paint. This should hoold the rust at bay for a few more years. -
A shot of the cowl after sanding and cleaning. A second cleaning should finish this off before applying the POR-15. The vacuum found lots of debris under this cowl. -
Another shot of the F54/P79 engine from the now departed '82 280ZX that was parted out last year. This engine came from the french beige '82 hardtop in my gallery. -
The hatch after having some trouble spots sanded. -
The passenger side headlight area. -
The passenger side inner fender well looking down from the top. -
The passenger side inner fender well. -
The passenger side inner fender well. -
The Motorsport springs are still looking good after seven plus years! -
I had rpeviously primed this area after sanding about 4 years ago. This time it will last much longer. This is a good chance to modify the rubber drain so that the water does not accumulate on the ledge below. -
Just before sanding.....notice the unpainted surfaces. Nissan sprayed just a thin film of primer here. A good opportunity to apply POR-15. -
orange fender removed and getting ready to revisit this area again. Last time I didn't get to finish preparing this area properly. -
The Nissan parts sticker is just about buried under the black skim coat. -
If you squint you just might see the Nissan parts sticker under that black skim coat. -
The nose of the passenger side fender. -
Another shot of the driver's side fender before installation. -
This is the passenger's side fender for the '78 280Z I have for sale. HLS30-448652 02/78 -
This is the driver's side fender for the '78 280Z I have for sale. HLS30-448652 02/78
