52crankman

Anyone have a source for the intake manifold water tube o-rings RING-RUBBER - NISSAN (14013-73400). I managed to get the tube and ends disassembled and now need to replace the o-rings.

Just wanted to make sure there wasn't something else keeping it from coming out. It seems to be a tight fit. Did you replace the seal. Do you use a SKF 6641 to replace it. The current seal has a flange at the top.

Now another problem. Can not get the rack out either end. It seems like it hits a stop. Took the top snap ring off and tried to pull the bearing and pinion put it will not come out. What tricks did you use to get it apart?

Thanks for the tip. Worked like a charm.

Thanks. I'll give it a try. Did you measure the location so you could get them in the same location upon reassembly or just screw them on tight?

I was using that article when I ran into my problem. His rack is a bit different.

I have a 1972 (July) 240Z. Can anyone help with my steering rack disassembly. I have what I am going to call rack stops that are steel rings about 35mm OD on each end of the rack. They seem to have some type of rubber that can be seen on each side at the ID. Does anyone know if these are just pressed on and can be removed and then reused. I want to be able to finish disassembling my rack but the stops are causing a problem. I have tried twisting but they do not move. I do not want to destroy them. I believe this came from the factory as I am the second owner of this car and purchased it back in 1977.

You can send additional info to my email: ajpope@verizon.net

How much do you want for them.

Anyone have experience using these rotors. Look to be the vented type. Will they work on a stock 1972 240Z? Any problems with warpage. What is correct part number. I have seen 126-42004SL shown but not sure it is correct. This part number does not show on the Stop Tech web site for this model and year. Looking for any upgrade to the stock rotor for street use. Any suggestions for pads to use with them?

I am restoring this car and want to replace the bushings. Interesting all other bushings are still available but have not yet found a source for these. They seem to still be in good condition but would rather replace them after all these years.

All ready tried them with not luck. No luck with searching the web either.

Anyone have a source for the OEM engine mounting bushings (11345-N3000) that are pressed into the rear manual transmission mount.

Yes. Item 14 is what I want in OEM style. Do you know who has them available?

anyone have a source for the engine mounting bushings that are pressed into the rear manual transmission mount.

Thanks for the information. Now all I need to do is figure out how I can get one to the states.

Anyone know where to purchase this type of front air dam?