brake and fuel line brackets "opaque "flame yellow"

Hey, you weren't able to source any of the rubber bushings for these were you?

Eastwood has a 3 step paint system that does a pretty fair job of duplicating a cadmium finish (http://www.eastwood.com/jump.jsp?itemID=728&itemType=PRODUCT&path=1%2C2%2C389%2C390%2C397&KickerID=126&KICKER). I used it on my brake/fuel lines, and also a few miscellaneous bits under the hood. Not perfect, but a lot cheaper than cadmium plating, and gives a good look.

Mike, I just cleaned them with gasoline to remove all the overspray, tar, grease and oil. I use an eagle-1 product to make the rubber look new. I believe it was Tire dressing oil. the finished product looks brand new and shiny.

Kenny, I use the Eastwood zinc electro-plating system before the yellow paint. it coats it with zinc to keep the rust at bay.