Jump to content
Sign in to follow this  
gnosez

BSR Header and Collectors

Recommended Posts

Not very pretty but here is the header Z-Ya and I got with the rest of Bob Sharp Racing parts a few years back. The header studs on #1 & #6 are too big so they are hanging there just for the picture.

Two 3 pipe collectors with tabs and springs funnel the flow back to the dual trumpets in the rear.

 

It looks more like a prototype than one that was actually used. The welding in some places seems to have been done with old wire coat hangers on very thin metal using a bunch of truck batteries. I have to ask JR Mitchell if this was made at the track in an attempt to get the car back up and running.

 

The #5 will hit the steering shaft if you haven't altered the engine mounts to move it over about 3/4-inch to the right. That helps put some weigh over to the right front tire as well

BSRHeaderLseries.jpg

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.