Hey all

I bought my 240z a little bit ago (last year oct) and loved it. But a few months ago i had the car randomly just die on me on the freeway. I cranked it a few times and it started and I drove it around for a couple more week with intermittent problems where it would just die. but now I cannot even start the car. I did a bit of research and and it seems like the e12-80 is malfunctioning but while taking apart my distributor i noticed there is a pertronix electronic ignition in there.

So now I am not sure what i should do....should i buy a new distributor (looking at a chevy HEI) or should i just try a new e12-80 (where should i buy one of those?)

Also is there anything else I should consider before I start replacing things?

thanks in advance...

Edited April 26, 201214 yr by mz-n10

I suggest you check on your ignition switch, that causes similar issues. Do a little search and you'll find tons of info

If it is the e12-80 module just switch to the GM module

http://www.zhome.com/ZCMnL/tech/gmhei.html

FWIW,

Carl B.

If you have a Pertronix unit, that means you have a points distributor which was converted to electronic triggering. The E12-80 module is only relevant if you're using a 280ZX distributor. If you have the Pertronix installed, you don't have an E12-80 module.

thank you all.

i will do a search for the ignition switch and report back when i figure out if that is the issue.

Also remember that three things are required before an engine will start and run: Fuel, air and spark. If one or more of these three things is out of whack, you've got your situation.